VAL Avionics NAV 2000 Installation Guide download pdf (Page 99)

SV-ADAHRS-200/201 Installation and Configuration

SkyView System Installation Guide - Revision R 5-9

The values on this page are default values that act as placeholders. You must adjust these

values to work with your aircraft for any colors to show up on the IAS tape and also to be able to

calibrate the autopilot servos.

Vertical Speed Scale

Set the vertical speed scale on the Vertical Speed Scale Page (SETUP MENU > PFD SETUP >

VERTICAL SPEED SCALE).

G Meter

Go to this page (SETUP MENU > PFD SETUP > G METER) to configure the G meter.

The pop-up thresholds are G values that, when exceeded, will cause the G meter to display

automatically. The G meter replaces the HSI when it is displayed. In addition to popping up

automatically, the G meter can be manually toggled on and off using the PFD > G METER

button. If you do not want the G meter to ever be displayed automatically, set the positive pop-

up threshold value very high and the negative pop-up threshold value very low.

You can also set yellow and red cautionary ranges of the G meter here, and whether or not the

max/min recorded Gs are reset at each SkyView boot-up.

Synthetic Vision License

SkyView displays can be purchased with or without a license pre-installed that allows Synthetic

Vision to be shown. In order to display Synthetic Vision, each SkyView display must be

individually licensed to display it.

To check whether a display is licensed to display Synthetic Vision, go to SETUP MENU > LOCAL

DISPLAY SETUP > LICENSE, and look at the status of the SYNTHETIC VISION line. If it is licensed,

Synthetic Vision will be displayed as long as SkyView has a valid GPS position signal and has the

appropriate high resolution terrain database installed for the region of the world that you are

flying in. See the Terrain Data section of this manual for information about obtaining and

loading terrain data to SkyView (high resolution terrain data is available for free from Dynon

Avionics.)

To enable Synthetic Vision on displays that do not have it pre-installed, a license that allows a

single display to display Synthetic Vision can be purchased in one of two ways:

1. Call Dynon Avionics directly at 425-402-0433 with your SkyView display model (SV-D100

or SV-D700) and serial number (as displayed on the case sticker, or in SETUP MENU >

LOCAL DISPLAY SETUP > DISPLAY HARDWARE INFORMATION). A License Code can be

purchased for the particular display you wish to enable Synthetic Vision on. This six

character License Code is then entered in SETUP MENU > LOCAL DISPLAY SETUP >

LICENSE > LICENSE CODE.

2. A SkyView Synthetic Vision Certificate may be purchased from Dynon Avionics or any

authorized Dynon Avionics retailer. This certificate can be redeemed for a license code

that can be entered in SETUP MENU > LOCAL DISPLAY SETUP > LICENSE > LICENSE CODE

to enable Synthetic Vision. To redeem a certificate simply follow the instructions on the

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 400 401

No comments

VAL Avionics NAV 2000 Installation Guide Page 99