VAL Avionics NAV 2000 Installation Guide download pdf (Page 89)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration

SkyView System Installation Guide - Revision R 4-29

on. At network configuration time, all other displays that are set to the default tail

number of DYNON will automatically have their settings and tail number

synchronized with the display the configuration is performed from. After

configuration, all displays’ tail numbers and settings will be synchronized, and

further setup tasks can be performed from any display.

Screen Layout Setup

As of SkyView software 5.0, you can use Screen Layout Setup page (SETUP MENU > SYSTEM

SETUP > SCREEN LAYOUT SETUP) to customize and restrict the ways that the PFD Page, Engine

Page, and Map Page are displayed on your SkyView display(s). This feature can be used in a

variety of ways:

 You can prohibit and restrict the use of certain menu items in the SCREEN menu. This can

allow you to:

o Enforce the relative layout of the PFD/Engine/Map pages on each display, for a

consistent cockpit environment

o Restrict the ability to remove Pages from a display. This can be used, for example, to

force the PFD Page and the Engine Page always be displayed on a display or in the

system.

 In multi-display systems, you can specify a reversion mode that automatically changes the

screen configuration to a specific layout when only one display remains powered on. For

example, if you normally have your left display showing PFD, and your right display showing

Engine and Map, you could configure reversion mode to show all three pages automatically

on the remaining single display should the other fail.

Menu items and settings available in the SCREEN LAYOUT SETUP menu include:

 General Rules – Settings under this menu control behavior of items contained under the

SCREEN menu. This applies to all displays in the system, no matter which display you change

these settings from.

o Show Layout Button: Determines whether the SCREEN > LAYOUT button is available

for use. The SCREEN > LAYOUT button allows the pilot to dynamically rearrange the

order of the PFD/ENGINE/MAP pages on a display.

o Show Swap Button: Determines whether the SCREEN > SWAP button is available for

use. The SCREEN > SWAP button allows the pilot to swap the entire contents and

page layouts of displays in a two-display SkyView System.

 This Display – Normal Operation: The options under this menu apply only to the display that

you are currently working with, and only when the system is operating normally (when the

display is not in reversion mode or swapped)

o PFD Page, Engine Page, Map Page: For each of these entries, you can control

whether each page is:

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 400 401

No comments

VAL Avionics NAV 2000 Installation Guide Page 89