VAL Avionics NAV 2000 Installation Guide download pdf (Page 344)

Appendix A: Maintenance and Troubleshooting

20-4 SkyView System Installation Guide - Revision R

8. On the recently repaired display, confirm that the tail number under SYSTEM SETUP >

AICRAFT INFORMATION is now set to the actual aircraft tail number, not DYNON. This

implies that all settings and configurations have been synchronized from the other

display.

SV-ADAHRS-200/201 Modules

1. Reinstall the ADAHRS in the aircraft.

2. Reconnect all harnesses and connections as originally installed.

3. Power up the entire SkyView System (all displays, modules, servos, etc.).

4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >

SYSTEM SETUP > NETWORK SETUP > CONFIGURE…

5. Confirm all SkyView Network components are found, including the reinstalled ADAHRS.

6. If the ADAHRS is the same serial number as the one you returned for repair, no further

actions should be required. However, Dynon recommends double checking the

performance of magnetic heading and AOA calibration. If these do not seem to work as

well as they previously did, redo those calibrations.

7. If the ADAHRS is not the same serial number as the one you returned for repair, all

setup and calibration steps in the SV-ADAHRS-200/201 Installation and Configuration

section of the SkyView Installation manual should be performed because this ADAHRS is

being installed for the first time.

Autopilot Servos

1. Reinstall the servo in the aircraft.

2. Reconnect all harnesses and connections as originally installed.

3. Power up the entire SkyView System (all displays, modules, servos, etc.).

4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >

SYSTEM SETUP > NETWORK SETUP > CONFIGURE…

5. Confirm all SkyView Network components are found, including the reinstalled servo.

6. Assuming the Autopilot was previously set up and working correctly, you only need to

recalibrate the servos by going to SETUP MENU > HARDWARE CALIBRATION > SERVO

CALIBRATION > CALIBRATION and following the on-screen instructions.

All other SkyView Network Components

1. Reinstall the SkyView Network component in the aircraft.

2. Reconnect all harnesses and connections as originally installed.

3. Power up the entire SkyView System (all displays, modules, servos, etc.).

4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >

SYSTEM SETUP > NETWORK SETUP > CONFIGURE…

5. No further action should be required.

Operational Status

SkyView displays give users access to vital operational information in the Display Hardware

Information Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAY HARDWARE

1 2 ... 339 340 341 342 343 344 345 346 347 348 349 ... 400 401

No comments

VAL Avionics NAV 2000 Installation Guide Page 344