VAL Avionics NAV 2000 Installation Guide download pdf (Page 50)

Basic SkyView Display Operation

3-8 SkyView System Installation Guide - Revision R

You may also access the Setup Menu from the In Flight Setup Menu by using the ENTER FULL

SCREEN SETUP MENU… option.

How to Adjust Time Zone Offset

Enter the Time Zone Offset Page (SETUP MENU > SYSTEM SETUP > TIME > TIME ZONE OFFSET)

and adjust the time zone accordingly. Note that this is the local offset from Zulu time.

How to Configure Displayed Units

Displayed units can be configured for altitude, distance and speed, temperature, barometer,

pressure, and volume. Displayed units are configured on the Measurement Units Page (SETUP

MENU > SYSTEM SETUP > MEASUREMENT UNITS).

Screens and Menus

This section lists all of the screens, menus, and pages in the SkyView system.

Some menu options are dependent on installed, networked, and/or calibrated

SkyView equipment. For example, if there are no servos present in the SkyView

network, the AUTOPILOT Menu will not be present on the Main Menu. This guide

makes it clear where these dependencies exist in their applicable sections.

Main Menu

This menu is displayed right after the SkyView display boots up similar to Figure 10 and contains

links to the following menus:

 PFD – This menu allows users to turn the G Meter on and off, turn synthetic vision on or off,

select the NAV source, select bearing sources, and toggle bugs on and off.

 ENGINE – This menu allows users to control engine-related features such as adjusting the

fuel computer state (if equipped), enabling lean-assist mode, and interacting with VP-X (if

equipped).

 AUTOPILOT – This menu allows users to toggle the status of each installed autopilot axis, set

their respective modes, and engage the autopilot in a 180° turn from the current ground

track. This menu is only accessible if the autopilot servos have been properly installed,

networked, calibrated, and tested

 XPNDR – This menu allows users to control a Dynon SV-XPNDR-261/262 transponder, if

equipped.

 MAP – This menu allows users to control the Navigation Mapping Software features of

SkyView. Note that this button only appears when the SV-MAP-270 software has been

purchased and licensed, or when it is in its 30 hour free introductory trial period.

 SCREEN – This menu allows users to set the backlight level, toggle the state of the three

information pages (PFD, ENGINE, and MAP), and change the layout of the screen.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 400 401

No comments

VAL Avionics NAV 2000 Installation Guide Page 50