VAL Avionics NAV 2000 Installation Guide download pdf (Page 55)

Basic SkyView Display Operation

SkyView System Installation Guide - Revision R 3-13

 SHOW WIDE ANGLE VIEW BUTTON – Enables / disables the appearance of the WIDE button

PFD > MODE menu.

If you enable or disable WIDE view, then set SHOW WIDE ANGLE VIEW BUTTON to NO, the

previous wide setting (enabled or disabled) will persist. Example:

1. SHOW WIDE ANGLE VIEW BUTTON > YES

2. PFD > MODE > WIDE (gray background, indicating wide angle view is enabled)

3. SHOW WIDE ANGLE VIEW BUTTON > NO

Will result in:

 The WIDE button will not appear in the PFD > MODE menu

 Wide angle view will always be displayed in the PFD.

 BARO MISMATCH WARNING – Enables / disables a warning message when the current

SkyView BARO setting and nearest valid ADS-B METARS report barometric pressure are

significantly different.

EMS Setup Menu

This menu contains links to the following wizards and menu:

 Engine Information – Enter this wizard to record important information regarding the

engine in your aircraft such as engine type and horsepower. The user-entered information

here is used to calculate quantities such as % power and special operating limitations.

 Sensor Input Mapping... – Enter this wizard to map engine and environmental sensors to SV-

EMS-220/221 pins. Reference the EMS Sensor Input Mapping Section of this guide for

instructions on how to navigate and use this menu to map sensors.

 Screen Layout Editor – Enter this wizard to configure the placement and style of the

onscreen EMS gauges on EMS pages. Reference the EMS Screen Layout Editor Section of

this guide for instructions on how to use this wizard.

 Sensor Setup–Enter this menu to configure the graphical display properties of mapped

sensors. Reference the EMS Sensor Setting Section of this guide for more information

regarding sensor setup.

MAP Setup Menu

This menu contains links to the following wizards and menus:

 Terrain Warning Colors – Sets whether red and yellow terrain warning are provided on the

Map Page

 Red and Yellow Start – When the above setting is set to “YES”, these settings how far above

or below the aircraft’s current altitude the red and yellow colors persist.

Autopilot Setup Menu

This menu is not accessible until the autopilot servos in the system have been

successfully calibrated and tested. Reference the Autopilot Servo Calibration and

Test Procedures Section of this guide for more information.

This menu contains links to the following menus:

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 400 401

No comments

VAL Avionics NAV 2000 Installation Guide Page 55