VAL Avionics NAV 2000 Installation Guide download pdf (Page 47)

Basic SkyView Display Operation

SkyView System Installation Guide - Revision R 3-5

SkyView Touch

SV-D1000T displays can be controlled via touch in addition to using the conventional buttons

and joystick knobs. During normal usage, many of the on-screen elements can be touched to

control SkyView. Details about how touch is used in-flight are covered in the SkyView Pilot’s

User Guide. However, touch controls are not enabled in the SkyView Setup Menu and aren’t

generally used during installation and initial setup.

Menu Navigation

After the display turns on, you will see a screen similar to the one in Figure 10. This guide refers

to the label bar at the bottom of the screen as the Main Menu.

Throughout this guide, the “>” character is used to indicate a sequence of menu selections or

other actions you would take as you navigate the menu system. Menu selections which are

followed by “…” indicate full-screen wizard interfaces which guide you through the appropriate

steps. These wizard interfaces are not described in detail in this guide, as the on-screen

instructions provide adequate information.

SkyView menus follow this structure: SETUP MENU > MENU > ... > MENU > PAGE or WIZARD.

The setup menus (In Flight Setup or Setup) are the root of most menu navigation. Each nested

menu is more specific than the previous one and there is no set limit for the number of nested

menus before reaching a page. A page or wizard is at the end of the chain and it is where the

user can perform a specific action such as change a specific setting, configure a SkyView

network, or set up the layout of the onscreen engine gauges. Wizards employ easy-to-follow

onscreen instructions.

For example, SETUP MENU > SYSTEM SETUP > MEASUREMENT UNITS > BAROMETER indicates

entering the SETUP MENU, then selecting SYSTEM SETUP, then selecting MEASUREMENT

UNITS, and then entering the BAROMETER Menu to select INHG, MBAR, or MMHG.

Table 7 is a summary of menu navigation.

Desired Menu Action

User Action

Enter the Setup Menu

Simultaneously press and hold buttons 7 and 8

(if airspeed is greater than zero, you will enter the

In Flight Setup Menu)

Scroll through different menus

Turn either joystick

Move either joystick up or down

Enter menu

Move either joystick toward the right

Return to previous menu

Move either joystick toward the left (saves settings)

Press BACK (saves settings)

Press CANCEL (does not save settings)

Save adjusted value

Press ACCEPT

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 400 401

Comments to this Manuals

No comments

VAL Avionics NAV 2000 Installation Guide Page 47

Comments to this Manuals