VAL Avionics NAV 2000 Installation Guide download pdf (Page 90)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration

4-30 SkyView System Installation Guide - Revision R

 Required: The relevant page is always shown on this display. This is always

shown on this display. The relevant page button under the SCREEN menu is

not available.

 Allowed (Save State): This display remembers whether the relevant page was

being shown across power cycles. The relevant SCREEN button turns that

page on and off on this display.

 Allowed (Not Shown at Boot): The relevant page is never on at boot. The

relevant page button under the SCREEN menu turns that page on and off on

this display.

 Allowed (Shown at Boot): The relevant page is always on at boot. The

relevant page button under the SCREEN menu turns that page on and off on

this display.

 NOT ALLOWED: The relevant page cannot be shown on this display. The

relevant SCREEN button is not available.

 Reversion Mode Configuration – When only one display is powered on in a multiple display

configuration, the layout picked here is forcibly displayed. This behavior applies equally

whether all but one display in your system has failed or if you turn on one SkyView display

before all others (as some customers do to see engine instruments before engine start).

This setting applies to all displays in the system, no matter which display you change this

settings from.

o Disabled: Reversion Mode is disabled. The layout that was set on any display

remains the same whether or not it is the only display powered on in a multi-display

system.

 PFD 40% / EMS / MAP 40%

 PFD 50% / MAP 50%

 PFD 50% / EMS 50%

 PFD 80% / EMS 20%

 PFD 100%

Touch Setup

SkyView SV-1000T has settings that are specific to the touch interface: SETUP MENU > LOCAL

DISPLAY SETUP > TOUCH SETUP. This menu will not appear on units other than an SV-D1000T.

> TOUCH ENABLED – YES/NO – Enables / disables touch features on a SV-D1000T. When set to

NO, an SV-D1000T behaves exactly as an SV-D1000.

> SHOW TOUCHES – YES/NO – Enables / disables a small circle to appear on the touch screen

showing where the touch screen is sensing finger(s). SHOW TOUCHES is primarily used for

diagnostics / troubleshooting and is not normally enabled.

> KEYBOARD LAYOUT – A-Z | QWERTY – Selects the keyboard layout of the onscreen keyboard

that appears when alphanumeric character input is required (such as creating flight plans).

> HARDWARE STATUS, EVENT COUNTER, POINT #1, POINT #2, and TOUCH TEST… are used for

diagnostics / troubleshooting.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 400 401

No comments

VAL Avionics NAV 2000 Installation Guide Page 90