VAL Avionics NAV 2000 User's Guide Page 76

  • Download
  • Add to my manuals
  • Print
  • Page
    / 224
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 75
EMS Operation
5-10 SkyView Pilot’s User Guide - Revision Q
VP-X SkyView Interface Overview
SkyView’s VP-X page provides the ability for SkyView to view and control the following features
of the VP-X:
Show a list of all configured channels on the VP-X, including the starter, alternator, trim,
and flap channels.
Show the status of each circuit, whether on or off or faulted (and type of fault).
Total current draw of all circuits.
View the current draw, in amps, of each circuit, down to 1/10 of an Amp.
Reset a faulted circuit.
Show graphical electrical system diagram, including battery, alternator and system
currents, main bus voltage and aux aircraft battery voltage (if any).
Allow manual control of each individual circuit, including trim and flaps.
Display of trim and flaps position.
Pitch trim speed, as a percentage of maximum speed.
Display VP-X system faults.
On the Engine Page: Widgets for VP-X measured battery voltage, VP-X measured starter
status, and VP-X fault status can be added to any of the EMS pages via the EMS SETUP >
SCREEN LAYOUT EDITOR.
Displaying the VP-X Page
The VP-X page is displayed on-demand by pressing MAIN MENU > ENGINE > VP-X. In addition to
bringing up the VP-X page alongside the Engine Page, this will also bring up the VP-X menu
along the bottom of the display. Once in the VP-X menu, pressing BACK will both close the VP-X
page and back out of the VP-X menu.
Because the VP-X page is part of the Engine Page, the Engine Page must be visible on the
display that you are trying to access the VP-X page on. The ENGINE page can be toggled on and
off on a display by pressing MAIN MENU > SCREEN > EMS PG.
The Engine Page dynamically resizes to accommodate the VP-X page alongside of it. If all of the
PFD, Engine, and Map Pages were being displayed when the VP-X page is toggled on, the Map
Page will automatically be removed to accommodate the VP-X page. When you turn the VP-X
page off, the Map Page will automatically be re-opened.
Page view 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 223 224

Comments to this Manuals

No comments