VAL Avionics NAV 2000 User's Guide download pdf (Page 215)

Messages and Alerts

SkyView Pilot’s User Guide - Revision Q 11-11

should treat this error similarly to the way you would treat the failure of a single ADAHRS in a

system that is equipped with two of them: There is little you can do to troubleshoot such an

issue in flight, should it occur. However, you should exercise the same precautions you would

exercise if you did not have backup flight instruments. If you are flying in IMC, especially, you

should consider making a precautionary landing as soon as possible. Since a STANDBY

NETWORK ERROR may be either a discrete single failure (breakage of a single wire) or indicative

of a more serious failure in progress (an entire wire bundle that is slowly fraying against

another object), Dynon Avionics recommends that the root cause of the failure is determined

before flying again.

The SkyView System Installation Guide has troubleshooting procedures for finding the root

cause of standby network errors.

AOA Alerts

When AOA audio alerting is enabled, it enables a progressive tone that increases in intensity as

AOA increases. It is similar in nature to a conventional reed-type aircraft stall warning sound,

although it is much more predictable in its progression. It can be set to start its progressive

tones at either the border of the yellow/green marks on the AOA bars, the middle of the

yellow, or at the yellow/red border. The tones start at the level selected and get progressively

quicker and closer together until a solid tone is played at critical AOA (in the red).

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 223 224

No comments

VAL Avionics NAV 2000 User's Guide Page 215